Home > Tech > Why is the cleaning of FAG bearings important?

Why is the cleaning of FAG bearings important?

wallpapers Tech 2020-07-29
It is important to keep FAG bearings and lubrication clean.
Before checking the FAG bearing, clean the surface of the machine, and then disassemble the parts around the FAG bearing. The oil seal is very fragile, so you need to be careful to remove it, do not use excessive force, and then carefully check the oil seal and its surrounding parts. If it shows bad symptoms, it must be replaced. Poor oil seals can cause damage to FAG bearings and cause equipment downtime.
 
Check FAG bearing lubricant
Rub a little lubricant between two fingers. If there is contamination, you can feel it, or apply a thin layer of lubricant on the back of your hand, and then seal the lamp for inspection.
 
Replace FAG bearing lubricant
After the old oil in the oil-lubricated bearings is drained, if possible, add fresh oil and allow the machine to rotate at a low speed for a few minutes. The oil should collect the remaining contaminants as much as possible, and then drain the oil. It is best to filter the oil before use.

Say something
  • All comments(0)
    No comment yet. Please say something!
Tag: